Sugarhouse Sums › Boil time
Maple Sap Boil Time Calculator
Boil time = water to remove ÷ your evaporation rate. Nearly all of the sap is water: 10 gallons of 2% sap means boiling off about 9.8 gallons. At 1 gallon an hour (a big pot on a turkey-fryer burner) that is about 10 hours; on a 2×3 wood-fired pan at 6 gallons an hour, a little over 1½ hours.
Boil time by setup
| Setup (typical rate) | 5 gal sap | 10 gal | 20 gal | 40 gal |
|---|---|---|---|---|
| Pot on a kitchen stove (0.25 gal/h) | 20 h | 39 h | 78 h | 156 h |
| Turkey-fryer burner, big pot (1 gal/h) | 4.9 h | 9.8 h | 20 h | 39 h |
| Steam-table pans, block arch (1.5 gal/h) | 3.3 h | 6.5 h | 13 h | 26 h |
| 2×3 ft flat pan (6 gal/h) | 0.8 h | 1.6 h | 3.3 h | 6.5 h |
| 2×4 ft flat pan (8 gal/h) | 0.6 h | 1.2 h | 2.4 h | 4.9 h |
| 2×6 ft with flue pan (15 gal/h) | 0.3 h | 0.7 h | 1.3 h | 2.6 h |
What sets the rate
- Pan surface area. Wood-fired flat pans manage very roughly 1–2 gallons per hour for each square foot; flue pans and a strong draft push that higher.
- Heat. A pot on a 55,000 BTU burner cannot evaporate more than about 2–3 gallons an hour even at perfect efficiency. Use the burner calculator.
- Depth and wind. Shallow sap (1–2 inches) boils off faster, but too shallow risks scorching. Wind blows the heat away from an open pot.
Remember to add warm-up time: bringing a full pot of near-freezing sap to the boil can take as long as an hour on a small burner.
Questions sugarmakers ask
How long does it take to boil 5 gallons of sap?
About 5 hours on a turkey-fryer burner at 1 gallon an hour, under an hour on a 2×3 wood-fired flat pan, and the best part of a day or more on a kitchen stove.
Should I boil sap indoors?
Only for the last stage. Boiling gallons of sap indoors releases gallons of water vapour that can peel wallpaper and soak a kitchen. Boil down outside and finish inside.
How we calculate: sap-to-syrup ratios come from a sugar mass balance using sucrose solution densities (sap and syrup are mostly sucrose), shown next to the familiar Rule of 86. Finished syrup is taken as 66.9 °Brix unless you change it. Tapping guidelines follow the conservative diameter rules published by US university extension services (Maine, Cornell, Utah State). Boiling uses about 8,100 BTU to evaporate one US gallon of water. Figures are estimates for planning, not a guarantee of yield or quality.