Sugarhouse Sums › Fuel for boiling
Propane and Firewood for Boiling Sap
Boiling 40 gallons of 2% sap down to a gallon of syrup takes about 40–45 lb of propane (two 20 lb tanks) in an open pot at 35% efficiency. On a wood-fired arch it is roughly a twentieth to a tenth of a cord, depending on how efficient the arch is. Efficiency matters more than anything else in this estimate.
Propane for common batches
| Sap (2%) | 25% eff. | 35% eff. | 50% eff. |
|---|---|---|---|
| 10 gal | 15 lb | 10 lb | 7 lb |
| 20 gal | 29 lb | 21 lb | 15 lb |
| 40 gal | 59 lb | 42 lb | 29 lb |
| 80 gal | 117 lb | 84 lb | 59 lb |
| Syrup made (2% sap) | Block arch, 20% | Arch with flat pan, 35% | Good evaporator, 50% |
|---|---|---|---|
| 1 gal syrup | 0.09 cord | 0.05 cord | 0.03 cord |
| 5 gal syrup | 0.43 cord | 0.25 cord | 0.17 cord |
| 10 gal syrup | 0.87 cord | 0.5 cord | 0.35 cord |
| 25 gal syrup | 2.17 cord | 1.24 cord | 0.87 cord |
The often-quoted “one cord of wood for 20–30 gallons of syrup” matches a reasonably efficient evaporator. Simple block arches with open pans can burn two or three times as much.
Cutting fuel use
- Burn dry, split wood: green wood wastes much of its heat boiling off its own water.
- Insulate the arch and keep the firebox door shut between loads.
- Concentrate sap first if you have a small RO unit or freeze-concentrate in a cold snap (pour off the sweeter liquid and discard the ice).
Questions sugarmakers ask
How many 20 lb propane tanks to make a gallon of syrup?
About two in an open pot at typical efficiency, or one and a half with a good wind shield and wide pan.
How much firewood for maple syrup?
Very roughly a twentieth to a thirtieth of a cord per gallon of syrup on a decent wood-fired evaporator, and two or three times that on a simple open-pan arch.
How we calculate: sap-to-syrup ratios come from a sugar mass balance using sucrose solution densities (sap and syrup are mostly sucrose), shown next to the familiar Rule of 86. Finished syrup is taken as 66.9 °Brix unless you change it. Tapping guidelines follow the conservative diameter rules published by US university extension services (Maine, Cornell, Utah State). Boiling uses about 8,100 BTU to evaporate one US gallon of water. Figures are estimates for planning, not a guarantee of yield or quality.