Maple Sap to Syrup Calculator
At 2% sugar it takes about 44 gallons of sap to make 1 gallon of syrup (the Rule of 86 says 43). Sweeter sap needs less: about 35 gallons at 2.5% and 29 at 3%. Thin red-maple sap at 1.5% needs nearly 59.
Enter your sap and its sugar reading below. The calculator follows the sugar, so it works for any amount and in gallons or litres.
Sap to syrup ratio chart
| Sap sugar (°Brix) | Sap for 1 US gal syrup | Sap for 1 litre syrup | Rule of 86 |
|---|---|---|---|
| 1% | 88.3 gal | 88.3 L | 86 |
| 1.5% | 58.8 gal | 58.8 L | 57.3 |
| 1.8% | 48.9 gal | 48.9 L | 47.8 |
| 2% | 44 gal | 44 L | 43 |
| 2.2% | 40 gal | 40 L | 39.1 |
| 2.5% | 35.1 gal | 35.1 L | 34.4 |
| 3% | 29.2 gal | 29.2 L | 28.7 |
| 3.5% | 25 gal | 25 L | 24.6 |
| 4% | 21.8 gal | 21.8 L | 21.5 |
How the calculation works
Boiling only removes water, so every gram of sugar in the sap ends up in the syrup. The calculator finds the sugar in your sap (volume × density × sugar fraction) and divides by the sugar in a litre or gallon of finished syrup. That is why the ratio is the same whether you work in gallons, litres or quarts.
The Rule of 86 (86 ÷ sugar %) is the quick version sugarmakers have used for decades. It runs about 2–3% lower than the mass balance because it was fitted to slightly thinner syrup. Either is fine for planning; your real yield will be a little lower again once you lose some to sugar sand, filters and the pan.
Worked examples
- 15 gallons of 2.2% sap → 15 ÷ 40 = 1.5 quarts of syrup (1.42 L).
- 200 litres of 1.8% sap → 200 ÷ 48.9 = 4.09 litres of syrup.
- Want 2 gallons of syrup with 2.5% sap? Collect 2 × 35.1 = 70 gallons of sap, plus 5–10% for losses.
No hydrometer yet?
Use 2% for sugar maple sap early in the season and 1.5–2% for red or silver maple. A sap hydrometer or a cheap optical refractometer pays for itself in the first season, because sugar content can swing from below 1.5% to over 3% between trees and weeks.
Questions sugarmakers ask
How many gallons of sap make a gallon of maple syrup?
About 40 to 45 gallons for typical 2% sugar maple sap. The exact figure depends on the sap’s sugar: divide 86 by the sugar percentage for a quick estimate.
Does the ratio change if I use litres?
No. The ratio is the same in any unit: 44 litres of 2% sap make about 1 litre of syrup, just as 44 gallons make about 1 gallon.
Why did I get less syrup than the calculator says?
Some syrup is lost to sugar sand (niter), filters and the film left in the pan, and slightly thick syrup weighs more per gallon. A 5–10% shortfall is normal on small batches.
How we calculate: sap-to-syrup ratios come from a sugar mass balance using sucrose solution densities (sap and syrup are mostly sucrose), shown next to the familiar Rule of 86. Finished syrup is taken as 66.9 °Brix unless you change it. Tapping guidelines follow the conservative diameter rules published by US university extension services (Maine, Cornell, Utah State). Boiling uses about 8,100 BTU to evaporate one US gallon of water. Figures are estimates for planning, not a guarantee of yield or quality.