Sugarhouse Sums › Finishing temperature

Maple Syrup Finishing Temperature

Syrup is done at about 7 °F (4 °C) above the temperature at which water boils in your pot today — around 219 °F (103.9 °C) at sea level, lower at altitude. Then confirm with a hydrometer or refractometer: 66–67 °Brix.

Syrup finishing temperature

Best: boil plain water with the thermometer you will use.

Used only if the box above is blank.

Advertisement
Ad space

Finishing temperature by elevation

Standard atmosphere; weather can move these by about 1 °F
ElevationWater boils (average day)Syrup finishes
0 ft (0 m)212 °F219.1 °F (103.9 °C)
500 ft (152 m)211.1 °F218.2 °F (103.4 °C)
1,000 ft (305 m)210.2 °F217.3 °F (102.9 °C)
1,500 ft (457 m)209.3 °F216.4 °F (102.4 °C)
2,000 ft (610 m)208.4 °F215.5 °F (101.9 °C)
3,000 ft (914 m)206.5 °F213.6 °F (100.9 °C)
4,000 ft (1,219 m)204.7 °F211.8 °F (99.9 °C)
5,000 ft (1,524 m)202.9 °F210 °F (98.9 °C)

A reliable routine

  1. Each boiling day, boil plain water with the same thermometer and note the reading.
  2. Add 7 °F (4 °C). That is your draw-off target for the day.
  3. As you get within a couple of degrees, watch closely: the temperature climbs fast at the end.
  4. Check density with a syrup hydrometer at the temperature it is calibrated for, or cool a drop for a refractometer.
  5. Filter hot and bottle hot, following your bottle or jar maker’s guidance.

Too thick or too thin?

Syrup under about 66 °Brix can ferment or grow mould in storage. Over about 68 °Brix it tends to grow sugar crystals in the bottle. The density fix calculator works out how much water to add or how much to boil off.

Questions sugarmakers ask

What temperature is maple syrup done in Celsius?

About 4 °C above water’s boiling point: around 104 °C at sea level.

Can I make syrup without a thermometer?

It is possible to judge by how syrup ‘aprons’ or sheets off a spoon, but results vary a lot. A thermometer plus a hydrometer or refractometer is far more consistent.

How we calculate: sap-to-syrup ratios come from a sugar mass balance using sucrose solution densities (sap and syrup are mostly sucrose), shown next to the familiar Rule of 86. Finished syrup is taken as 66.9 °Brix unless you change it. Tapping guidelines follow the conservative diameter rules published by US university extension services (Maine, Cornell, Utah State). Boiling uses about 8,100 BTU to evaporate one US gallon of water. Figures are estimates for planning, not a guarantee of yield or quality.