Sugarhouse Sums › 10 gallons of sap
How Long to Boil 10 Gallons of Sap?
About 1½ to 2 hours on a 2×3 ft wood-fired flat pan (6 gal/h), 4–10 hours over a turkey-fryer burner, and well over a day on a kitchen stove. In every case you are boiling off about 9¾ gallons of water to leave roughly a quart (0.23 gal) of syrup.
10 gallons of sap by setup
| Setup | Rate | Boil time | Syrup |
|---|---|---|---|
| Pot on a kitchen stove | 0.25 gal/h | 39 h | 29 fl oz |
| Turkey-fryer burner, big pot | 1 gal/h | 9.8 h | 29 fl oz |
| Steam-table pans, block arch | 1.5 gal/h | 6.5 h | 29 fl oz |
| 2×3 ft flat pan | 6 gal/h | 1.6 h | 29 fl oz |
| 2×4 ft flat pan | 8 gal/h | 1.2 h | 29 fl oz |
| 2×6 ft with flue pan | 15 gal/h | 0.7 h | 29 fl oz |
Same 10 gallons at different sugar levels
| Sap sugar | Syrup | Water to boil off |
|---|---|---|
| 1.5% | 0.68 qt | 9.82 gal |
| 2% | 0.91 qt | 9.76 gal |
| 2.5% | 1.14 qt | 9.7 gal |
| 3% | 1.37 qt | 9.65 gal |
Sweeter sap gives more syrup but barely changes the boiling, because the water is almost all of it either way.
Making a 10-gallon day go faster
- Pre-warm sap in a second pot at the back of the fire so cold sap never hits the boiling pan.
- Add sap little and often to keep the boil rolling instead of dumping a big batch.
- Block the wind and put a lid or shield around an open pot’s sides.
- Use wider, shallower pans: surface area matters more than volume.
Questions sugarmakers ask
How much syrup will 10 gallons of sap make?
About 29 fluid ounces (just under a quart) at 2% sugar, and about 36 ounces at 2.5%.
How much propane to boil 10 gallons of sap?
Typically 10–12 lb with an open pot on a burner, about half of a 20 lb barbecue tank. See the fuel calculator.
How we calculate: sap-to-syrup ratios come from a sugar mass balance using sucrose solution densities (sap and syrup are mostly sucrose), shown next to the familiar Rule of 86. Finished syrup is taken as 66.9 °Brix unless you change it. Tapping guidelines follow the conservative diameter rules published by US university extension services (Maine, Cornell, Utah State). Boiling uses about 8,100 BTU to evaporate one US gallon of water. Figures are estimates for planning, not a guarantee of yield or quality.