Sugarhouse Sums › Stove or turkey fryer
Boiling Sap on a Stove or Turkey Fryer
A 55,000 BTU turkey-fryer burner under a wide pot boils off about 1½–2½ gallons an hour in still air, and often around 1 gallon in wind. A large kitchen burner (about 10,000 BTU) manages roughly 1–1½ quarts an hour. Each gallon of water needs about 8,100 BTU to boil away.
Gallons per hour by burner and efficiency
| Burner | 20% (windy) | 35% (typical pot) | 50% (shielded, wide pan) |
|---|---|---|---|
| 10,000 BTU | 0.25 gal/h | 0.43 gal/h | 0.62 gal/h |
| 55,000 BTU | 1.36 gal/h | 2.38 gal/h | 3.4 gal/h |
| 100,000 BTU | 2.47 gal/h | 4.33 gal/h | 6.18 gal/h |
| 150,000 BTU | 3.71 gal/h | 6.49 gal/h | 9.27 gal/h |
Getting more from a burner
- Use the widest pot or pan the burner can safely hold; a wide, shallow pan catches more flame than a tall stockpot.
- Build a wind shield of blocks or sheet metal round the burner and pan, leaving air in at the bottom.
- Keep 1½–3 inches of sap in the pan and top up with pre-warmed sap.
Safety notes
Use propane burners outdoors only, on a level non-flammable surface, away from buildings, and never leave a boiling pan unattended. Do not run propane equipment in a garage or shed with the door closed. Follow the burner maker’s instructions.
Questions sugarmakers ask
Can I boil sap on my kitchen stove?
For a gallon or two, yes, but it is slow (roughly a quart an hour) and releases a lot of steam. Most people boil down outside and only finish on the stove.
Is a turkey fryer good for maple syrup?
It is a popular starter setup. Swap the tall fryer pot for a wide, shallow pan or steam-table pans if you can, which can roughly double the rate.
How we calculate: sap-to-syrup ratios come from a sugar mass balance using sucrose solution densities (sap and syrup are mostly sucrose), shown next to the familiar Rule of 86. Finished syrup is taken as 66.9 °Brix unless you change it. Tapping guidelines follow the conservative diameter rules published by US university extension services (Maine, Cornell, Utah State). Boiling uses about 8,100 BTU to evaporate one US gallon of water. Figures are estimates for planning, not a guarantee of yield or quality.